Free Basic Systems Available – Free Installation with a 36 month $25.00 a month agreement.
Common How-to Keypad Answers
Click here to download entire Keypad Manual
Bypassing Zones
Zones cannot be bypassed once the system is armed.
1. “Press ✱ for 1 Zone Bypass”.
2. Keypad will display “Zone Search < > Zone Name”. use “<” and “>” to find open zone or zone that you would like to bypass. If open, it will show “O”.
3. To Bypass a zone, push * and that zone will show “B” instead of “O”. To undo bypass of that zone, push * again and it will show “O”
4. When finished all bypassing, push # and you should be able to set your alarm.
Door Chime (Entry/Exit Beeps) To turn the door chime function on or off, press and hold the Chime key ( ) for 2 seconds or press 
| LED/DIGIT |
Trouble Condition |
Comments |
Action |
|
1 |
Service Required (Press [1] for more information) | (1) Low Battery (2) Bell Circuit (3) System Trouble (4) System Tamper (5) Module Supervision (6) RF Jam Detected (7) PC5204 Low Battery (8) PC5204 AC Failure |
Call for service |
|
2 |
Loss of AC Power | If the building and/or neighborhood has lost electrical power, the system will continue to operate on battery for several hours. |
Call for service |
|
3 |
Telephone Line Fault | The system has detected that the telephone line is disconnected. |
Call for service |
|
4 |
Failure to Communicate | The system attempted to communicate with the monitoring station, but failed. This may be due to Trouble 3. |
Call for service |
|
5 |
Sensor (or Zone) Fault | The system is experiencing difficulties with one or more sensors on the system. Press 6 to display the zone. |
Call for service |
|
6 |
Sensor (or Zone) Tamper | The system has detected a tamper condition with one or more sensors on the system. |
Call for service |
|
7 |
Sensor (or Zone) Low Battery | If the system has been equipped with wireless sensors, one or more has reported a low battery condition |
Call for service |
|
8 |
Loss of Time & Date | If complete power was lost (AC and Battery), the time and date will need to be re-programmed. |
Re-program Time & Date (page 6 in manual) |
| 9 Press , plus your Master Access Code. The Program or System indicator will begin |
|||